D-Cide 113 has a very broad activity spectrum against the bacteria, moulds and yeast that may cause deterioration of water based products during storage.

D-CIDE 113 is suitable for wet – state preservation of a wide range of aqueous products including paints, polymer emulsions, adhesives, ceramic glazes, fillers, slurries and sealant. Normal uses of concentration are in the range of 0.25 – 0.5 % depending on the product to be protected and environmental conditions to which it will be exposed.

For best results, it is advised to add D-CIDE 113 at led-down stage at a point of good agitation to ensure uniform distribution for maximum protection on storage. Inadequate distribution of biocide active ingredients will allow pockets of microbial growth to develop, product spoilage will result. Care should be taken to ensure temperature, pH and redox potential

D-CIDE 113 remain stable for at least 12 months while keeping it at room temperature. It needs protection from extreme temperatures, though it can tolerate several freeze and thaw cycles without causing product decomposition. The stock must be rotated on first in, first out basis.

25kg and 200kg